Meaning of grade for screws/bolts/external threaded parts

Oct 15, 2026 Leave a message

The grade of screws, bolts, and externally threaded fittings primarily indicates the material strength, mechanical properties, and load-bearing capacity of the fasteners, serving as crucial technical parameters in mechanical design and selection. For common carbon steel and alloy steel bolts, performance grades are typically represented by a combination of numbers, such as 4.8, 5.8, 8.8, 10.9, and 12.9. The first digit in the performance grade designation represents one-hundredth of the nominal tensile strength, and the product of the two digits represents the ratio of the nominal yield strength to the nominal tensile strength. For example, an 8.8 grade bolt has a nominal tensile strength of 800 MPa, a yield strength ratio of 0.8, and a nominal yield strength of 640 MPa; a 10.9 grade bolt has a nominal tensile strength of 1000 MPa and a nominal specified plastic elongation strength of approximately 900 MPa. Generally, a higher performance grade allows the bolt to withstand greater tensile loads, but also places higher demands on material quality, heat treatment processes, and manufacturing precision. Different grades of bolts are suitable for different working conditions. For example, grades 4.8 and 5.8 are typically used for general mechanical connections and structures with relatively small loads, grade 8.8 is often used for mechanical equipment bearing larger loads, and grades 10.9 and 12.9 are mostly used for mechanical transmission devices and important load-bearing structures with high connection strength requirements.

 

Stainless steel bolts also have independent grade marking methods, usually consisting of two parts: material group and performance grade, such as A2-70, A4-70, and A4-80. Here, the letter A indicates austenitic stainless steel, the numbers 2 and 4 represent different stainless steel material groups, and the following number 70 or 80 indicates the nominal tensile strength grade, corresponding to tensile strength levels of 700 MPa and 800 MPa, respectively. Stainless steel fasteners have good corrosion resistance and are suitable for humid environments, outdoor equipment, and some chemical machinery structures. It is important to note that the performance grade does not fully represent the actual performance capacity of the bolt; the load-bearing capacity of the fastener is also affected by factors such as thread diameter, effective cross-sectional area, thread engagement length, material properties, and working environment. Furthermore, when selecting bolts, nuts, and studs, the matching relationship between performance grades must be considered to avoid thread damage or connection failure due to grade mismatch. In actual mechanical design, the appropriate performance grade should be rationally selected based on the equipment's working load, vibration conditions, operating temperature, and corrosion conditions, and the design and verification should be carried out in accordance with relevant national standards or mechanical industry standards.